ISSN 1608-4039 (Print)
ISSN 1680-9505 (Online)


conductivity

Влияние методики синтеза на физико-химические свойства LaLi0.1Со0.1Fe0.8O3-δ

The phase composition, conductivity and corrosion resistance under the Molten Carbonate Fuel Cell (MCFC) operating conditions of synthesized using common ceramic and cocrystallization techniques samples of LaLi0.1Со0.1Fe0.8O3 – δ have been studied. It was found, that the phase composition of synthesized by ceramic technique sample differed from the nominal composition.

Impediance spectroscopy of modified potassium titanates. II

The electrochemical and electrophysical properties of basic and protonated potassium titanates in contact with the graphite electrodes were studied using the method of impedance spectroscopy. The characteristics of potassium titanates are given depending on the methods of modification and on the methods of their processing. The activation energies for some compositions were determined.

Electrophysical properties of ceramic materials based on manganese-containing potassium polytitanates

The new materials obtained in the potassium polytitanate (PPT)–MnSO4 system by modifying PPT in aqueous solutions of manganese sulfate of various concentrations, followed by thermal treatment and annealing at 1080°C, were synthesized and studied. The phase composition of the obtained materials was determined. Their electrochemical and electrophysical properties in the temperature range from 250 to 700°C were studied.

Impedance spectroscopy of modified potassium titanates. I

The electrochemical and electrophysical properties of the protonated and modified with silver iodide potassium titanates, which can be applied in energy storage units, have been investigated by impedance spectroscopy. It has been shown that the dielectric losses at medium and high frequencies are weakly dependent on the polarizing voltage. It has also been established that transfer in modified potassium titanate can be made through potassium and silver ions.

Influence of synthesis conditions on electrophysical properties of layered potassium polytitanates

The influence of the pH value in the dispersions during washing the potassium polytitanate powder (PPT) after its molten salt synthesis on electrical properties of the obtained product, namely conductivity, permittivity and tangent of dielectric losses. It is established that the samples obtained in weakly alkaline conditions (pH = 7.44 and 8.50), are characterized by higher values of low-frequency conductivity and dielectric permittivity (up to 10^{5), low value of the relaxation time (0.112 and 0.358, respectively).

Comparison of traditional organic solvents with phosphoric acid esters in lithium-ion and supercapacitor technologies

This work is dedicated to phosphoric acid esters working as solvents for lithium-ion and supercapacitor (SC) electrolyte. The electrical conductivity of electrolytes based on phosphoric acid esters, lithium salts, commonly used in lithium-ion batteries (LIB), and salts used in SC technology was measured. The thermodynamic stability of new electrolytes in comparison with other solvents used in chemical power sources technology was also estimated. It was shown that the thermodynamic stability of phosphoric acid ester increases in a homologous series.

Nonlinear effects in a cell with a solid electrolyte based on protonated potassium polytitanate

In this paper, the electrochemical and electrophysical properties of protonated potassium polytitanate synthesized at pH values varying from 3.11 to 8.88 depending on the magnitude of the polarization voltage and the magnitude of the measured signal were studied by the method of impedance spectroscopy. The values of effective conductivity, relaxation times, frequency dependences of the loss tangent, and dielectric permittivity are determined.

Solid proton-conducting ceramic electrolyte for energy storage units

The paper considers the electrochemical properties of potassium polytitanate synthesized at the values of pH varying from 3 to 8 in a wide temperature range from ? 26 to + 80°C. The conductivity values and the activation energy were determined with the help of the method of impedance spectroscopy. The application of the obtained material used as a ceramic solid electrolyte in the energy storage units operating at low temperatures in the Far North is considered in the article.